====== Electronics Area ======

===== Rules =====
  * Always clean the work area when you leave. Flag and/or clean up any mess left by others.
  * Only "Extra Low Voltage" projects are allowed to be worked on, unless you are a licensed QLD electrician.
  * Hot (heat) or Live (Powered) tools or projects must not be left unattended.
  * Live projects should be adequatly protected from accidental bumping, proding, spills. 
  * Communicate with others if you have sensitive equipment exposed on the bench. 
  * This is a learning area, not everyone is an electrical engineer but many are enquisitive. Be prepared to answer questions about your project.  
  * Every tool has a place, and there is a place for every tool. 
  * Report worn, broken or missing tools to cause leaders
Detailed policy information can be found on the [[teams:electronics| Electronics Team wiki page]].

===== Inductions =====
**Spot Welder -** 
   * Induction process is to demonstrate safe use of the tool and then get them to try it also.
**Reflow Oven - **
   * Induction process is to run through approved uses for the oven and how to achieve them and demonstrate use of front panel and default oven profiles.
   * Maintainer is Lucas Oldfield (BadBiki)
   * Work in progress... Finishing before EOY 2020!!

===== Tools =====
<nspages tools:electronics -exclude:home -usePictures -h1 -textNS="" -textPages="" -subns -pagesInNs -defaultPicture="{{:wiki:logo.png}}" -naturalOrder>

{{ :teams:electronics:electronics.jpg?nolink&600 |}}