Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision Both sides next revision
howto:upmini [2020/04/11 12:01]
127.0.0.1 external edit
howto:upmini [2020/04/12 02:21]
nogthree change to bootswrapper instead.
Line 6: Line 6:
     - A good rule of thumb is for every square CM of your print there should be 15CM on the spool.     - A good rule of thumb is for every square CM of your print there should be 15CM on the spool.
   - Initialise Printer   - Initialise Printer
-    - On the attached PC, run the 'UP 2.18' software. <WRAP center round info 60%>The Up Studio software isn't working with this printer anymore.</​WRAP>+    - On the attached PC, run the 'UP 2.18' software. <callout type="info" icon="​true"​>The Up Studio software isn't working with this printer anymore.</​callout>
     - On the Main Menu click 3D Print and then Initialize.     - On the Main Menu click 3D Print and then Initialize.
   - Insert Bed   - Insert Bed
Line 16: Line 16:
     - The printhead will start to heat up, within 5 minutes the printhead temperature will reach 260 degrees then the printer will buzz and the print head starts to extrude.     - The printhead will start to heat up, within 5 minutes the printhead temperature will reach 260 degrees then the printer will buzz and the print head starts to extrude.
     - Watch the printer push the filament out, making sure it's not coming out sideways. If it is, report it to the #digifab chat.      - Watch the printer push the filament out, making sure it's not coming out sideways. If it is, report it to the #digifab chat. 
-    - When it completes it will beep again, pull the filament out and it should be a nice smooth coil of filament. <WRAP center round important 60%>Do not reach up towards the nozzle, reach down towards the bed.</WRAP><WRAP center round info 60%>​If ​it is bubbly or textured ​report this to #digifab chat.</​WRAP><​WRAP center round info 60%>If the filament ​doesn'​t come out at all, report this to #digifab chat.</​WRAP>​+    - When it completes it will beep again, pull the filament out and it should be a nice smooth coil of filament. <alert type="​danger"​ icon="​fa fa-warning"​>Do not reach up towards the nozzle, reach down towards the bed.</alert><callout type="info" icon="​true"​>​If ​the filament ​is bubbly or textured ​or doesn'​t come out at all, report this to #digifab chat..</​callout>​</​WRAP>​
   - Set up Print   - Set up Print
   - Clean off Bed   - Clean off Bed
  
 Changing Filament Changing Filament
  • howto/upmini
  • Last modified: 3 years ago
  • by hsbnewiki