Electronics Area
Rules
- Always clean the work area when you leave. Flag and/or clean up any mess left by others.
- Only “Extra Low Voltage” projects are allowed to be worked on, unless you are a licensed QLD electrician.
- Hot (heat) or Live (Powered) tools or projects must not be left unattended.
- Live projects should be adequatly protected from accidental bumping, proding, spills.
- Communicate with others if you have sensitive equipment exposed on the bench.
- This is a learning area, not everyone is an electrical engineer but many are enquisitive. Be prepared to answer questions about your project.
- Every tool has a place, and there is a place for every tool.
- Report worn, broken or missing tools to cause leaders
Detailed policy information can be found on the Electronics Team wiki page.
Inductions
Spot Welder -
- Induction process is to demonstrate safe use of the tool and then get them to try it also.
Reflow Oven -
- Induction process is to run through approved uses for the oven and how to achieve them and demonstrate use of front panel and default oven profiles.
- Maintainer is Lucas Oldfield (BadBiki)
- Work in progress… Finishing before EOY 2020!!
