Both sides previous revision Previous revision | Next revision Both sides next revision | ||
howto:upmini [2020/04/12 02:21] nogthree change to bootswrapper instead. |
howto:upmini [2020/10/17 13:31] hsbnewiki |
||
---|---|---|---|
Line 6: | Line 6: | ||
- A good rule of thumb is for every square CM of your print there should be 15CM on the spool. | - A good rule of thumb is for every square CM of your print there should be 15CM on the spool. | ||
- Initialise Printer | - Initialise Printer | ||
- | - On the attached PC, run the 'UP 2.18' software. <callout type="info" icon="true">The Up Studio software isn't working with this printer anymore.</callout> | + | - On the attached PC, run the 'UP 2.18' software. <callout type="info" icon="true">Make sure you have opened Up 2.18, the 'Up Studio' software currently does not work with this printer.</callout> |
- On the Main Menu click 3D Print and then Initialize. | - On the Main Menu click 3D Print and then Initialize. | ||
- Insert Bed | - Insert Bed |
- howto/upmini
- Last modified: 4 years ago
- by hsbnewiki