Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tools:digitalfabrication:3dprinters:leftcr10 [2020/09/20 14:05] jabelone |
tools:digitalfabrication:3dprinters:leftcr10 [2021/10/14 13:12] davidjericho removed |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| ^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^ | ^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^ | ||
| + | | xx/08/2020 | Scott and Jaimyn | Swapped the mainboards around on the printers to get them up and running again (mainly Scott). | 1hr of time | | ||
| | 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time | | | 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time | | ||
| | 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time | | | 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time | | ||