Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tools:digitalfabrication:3dprinters:leftcr10 [2020/08/23 18:19] jabelone |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ==== Left CR-10 ==== | ||
| - | <WRAP center round alert 60%> | ||
| - | |||
| - | The Micro USB port is currently broken which means you cannot start a print directly in octoprint. Please upload and slice your gcode using octoprint, then download the .gcode file and place on the SD card. Then start the print from the SD card. | ||
| - | |||
| - | </WRAP> | ||
| - | |||
| - | {{:tools:cr-10.jpg?300&direct}} | ||
| - | |||
| - | **Internal Address:** [[http://left-cr10.hsbne.org/]] ([[http://10.0.1.152/]]) | ||
| - | |||
| - | **Maintainers:** Drew Spriggs and Jaimyn Mayer | ||
| - | |||
| - | **Maintenance:** | ||
| - | |||
| - | **22/08/2020:** | ||
| - | |||
| - | Who: Jaimyn Mayer | ||
| - | |||
| - | Why: Needed to use 3D printer. | ||
| - | |||
| - | What: | ||
| - | |||
| - | * Changed filament over to PLA and flushed old filament out. | ||
| - | * Re-levelled bed while printing as it was not level. | ||
- tools/digitalfabrication/3dprinters/leftcr10.1598170755
- Last modified: 4 years ago
- by
jabelone