Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Previous revision Next revision Both sides next revision | ||
tools:digitalfabrication:3dprinters:leftcr10 [2020/01/18 15:46] |
tools:digitalfabrication:3dprinters:leftcr10 [2020/09/20 14:05] jabelone |
||
---|---|---|---|
Line 1: | Line 1: | ||
==== Left CR-10 ==== | ==== Left CR-10 ==== | ||
- | {{:tools:cr-10.jpg?direct&300|}} | + | {{:tools:cr-10.jpg?300&direct}} |
- | **Internal Address:** http://left-cr10.hsbne.org/ (http://10.0.1.152/) | + | **Internal Address:** [[http://left-cr10.hsbne.org/]] ([[http://10.0.1.152/]]) |
- | **Maintainers:** Drew Spriggs | + | **Maintainers:** Drew Spriggs and Jaimyn Mayer |
+ | |||
+ | ===== Modifications / Repair History ===== | ||
+ | |||
+ | ^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^ | ||
+ | | 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time | | ||
+ | | 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time | |