Differences

This shows you the differences between two versions of the page.

--- tools:digitalfabrication:3dprinters:leftcr10 [2020/08/23 18:19]
jabelone
+++ tools:digitalfabrication:3dprinters:leftcr10 [2021/10/14 13:12]
davidjericho removed
@@ Line 1: / Line 1: @@
 ==== Left CR-10 ====
-<WRAP center round alert 60%>
-The Micro USB port is currently broken which means you cannot start a print directly in octoprint. Please upload and slice your gcode using octoprint, then download the .gcode file and place on the SD card. Then start the print from the SD card.
-</WRAP>
 {{:tools:cr-10.jpg?300&direct}}
@@ Line 13: / Line 7: @@
 **Maintainers:** Drew Spriggs and Jaimyn Mayer
-**Maintenance:**
+===== Modifications / Repair History =====
-**22/08/2020:**
-Who: Jaimyn Mayer
-Why: Needed to use 3D printer.
-What:
-  * Changed filament over to PLA and flushed old filament out.
+^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^
-  * Re-levelled bed while printing as it was not level.
+| xx/08/2020 | Scott and Jaimyn | Swapped the mainboards around on the printers to get them up and running again (mainly Scott). | 1hr of time |
+| 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time |
+| 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time |