Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tools:digitalfabrication:3dprinters:leftcr10 [2020/08/26 18:47] jabelone Removed broken usb port warning |
tools:digitalfabrication:3dprinters:leftcr10 [2020/09/20 18:39] jabelone [Modifications / Repair History] |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| **Maintainers:** Drew Spriggs and Jaimyn Mayer | **Maintainers:** Drew Spriggs and Jaimyn Mayer | ||
| - | **Maintenance:** | + | ===== Modifications / Repair History ===== |
| - | + | ||
| - | **22/08/2020:** | + | |
| - | + | ||
| - | Who: Jaimyn Mayer | + | |
| - | + | ||
| - | Why: Needed to use 3D printer. | + | |
| - | + | ||
| - | What: | + | |
| - | + | ||
| - | * Changed filament over to PLA and flushed old filament out. | + | |
| - | * Re-levelled bed while printing as it was not level. | + | |
| + | ^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^ | ||
| + | | xx/08/2020 | Scott and Jaimyn | Swapped the mainboards around on the printers to get them up and running again (mainly Scott). | 1hr of time | | ||
| + | | 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time | | ||
| + | | 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time | | ||