Both sides previous revision Previous revision | Previous revision Next revision Both sides next revision | ||
tools:digitalfabrication:3dprinters:leftcr10 [2020/01/23 12:16] |
tools:digitalfabrication:3dprinters:leftcr10 [2020/09/20 18:39] jabelone [Modifications / Repair History] |
||
---|---|---|---|
Line 1: | Line 1: | ||
==== Left CR-10 ==== | ==== Left CR-10 ==== | ||
- | <WRAP center round alert 60%> | + | {{:tools:cr-10.jpg?300&direct}} |
- | The Micro USB port is currently broken which means you cannot start a print directly in octoprint. Please upload and slice your gcode using octoprint, then download the .gcode file and place on the SD card. Then start the print from the SD card. | + | |
- | </WRAP> | + | |
- | {{:tools:cr-10.jpg?direct&300|}} | + | **Internal Address:** [[http://left-cr10.hsbne.org/]] ([[http://10.0.1.152/]]) |
- | + | ||
- | **Internal Address:** http://left-cr10.hsbne.org/ (http://10.0.1.152/) | + | |
**Maintainers:** Drew Spriggs and Jaimyn Mayer | **Maintainers:** Drew Spriggs and Jaimyn Mayer | ||
+ | |||
+ | ===== Modifications / Repair History ===== | ||
+ | |||
+ | ^ Date ^ Modified By ^ Description ^ Remediation ^ Cost ^ | ||
+ | | xx/08/2020 | Scott and Jaimyn | Swapped the mainboards around on the printers to get them up and running again (mainly Scott). | 1hr of time | | ||
+ | | 22/08/2020 | Jaimyn | Bed was found to be not level and incorrect filament loaded. | Loaded new roll of PLA and flushed out hotend. Levelled bed by adjusting the screws on each corner. | 1hr of time | | ||
+ | | 17/09/2020 | Jaimyn | Bed was found to be not level and OctoPrint was offline. | Fixed OctoPrint by reseating all of the power/network cables and changing DNS over to new IP address. Added static IP. Levelled bed by adjusting the screws on each corner. | 2hrs of time | |